| Post 1 made on Saturday January 3, 2004 at 12:25 |
Barry Gordon Founding Member |
Joined:
Posts: | August 2001
2,157 |
|
|
I am considering an iPronto. My Home theater is controlled by a ProntoPro sending IR to a PC, the PC then sending the proper IR command (or RS232 control sequences) to the A/V component. All logic is in the PC. The ProntoPro always sends NEC format IR which is very reliable.
I would want to do the same with the iPronto but using 802 to talk to the PC (It is on a wifi network) and just sending the PC simple commands in any reasonable format.
Does anyone know if this can be done (without the netX device), since I want the PC to act as the netX device. Can a "button" be configured to send via TCP/IP or UDP over wifi a simple command. It obviously does that (or something similar like sending the IR stream) to the netx device. Does anyone have the protocol for the IP transmissions between the iPronto and the netX?
|
|
| Post 2 made on Saturday January 3, 2004 at 17:17 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,902 |
|
|
the iPronto has a web browser. So if you build a web interface on the PC you should be able to control it using 802
|
... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
