Post 1 made on Sunday December 30, 2007 at 18:55 |
cagy Lurking Member |
Joined: Posts: | December 2007 1 |
|
|
I have a 659 that has a button that does not work. I tried to disassemble the remote to clean the contacts. Took out all the screws, but it was not obvious why it would not come apart. I didn't want to force it and end up doing damage. Is there anywhere online that has an exploded view of the remote or does it just pop apart after some prying? I found three screws to remove... is there something I'm missing? Thanx for any help!
Kelly
|
|
Post 2 made on Friday January 4, 2008 at 10:39 |
PistolPete2 Lurking Member |
Joined: Posts: | January 2008 1 |
|
|
There are actually 4 screws, 2 under the batteries & 2 near the front.
|
Pete |
|
Post 3 made on Friday January 4, 2008 at 16:00 |
chucksnet Long Time Member |
|
|
After you remove the four screws there are 6 latches. Three on each side. They are located at the widest points (4) and 2 at the narrowest point. Use a 1" putty knife at these points and push in on them to release the latch. I found this out the hard way.
|
|
Post 4 made on Friday January 4, 2008 at 17:30 |
chucksnet Long Time Member |
|
|
One more thing. I tried to clean the contacts without any success. I used a piece of the silver color duct tape (its peal and stick) and a small one hole punch that was the same size as the rubber contact to make the repair.
|
|
Post 5 made on Saturday January 5, 2008 at 13:25 |
jlet Super Member |
Joined: Posts: | March 2004 2,631 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.