| Post 1 made on Tuesday September 4, 2007 at 23:17 |
todd1010 Long Time Member |
Joined:
Posts: | December 2002
187 |
|
|
I was browsing around the setup of the devices with the Harmony 1000 and noticed these two ways of learning a IR command.
|
|
| Post 2 made on Wednesday September 5, 2007 at 08:40 |
Dark Knight Long Time Member |
Joined:
Posts: | December 2004
209 |
|
|
Learn mode matches the learned IR to an existing code in the database, whereas learn raw captures the exact signal received.
I expect the former case is best practice as this code would have been published by the manufacturer. Also, I imagine is uses less capacity on your remote's internal memory.
So, use 'Learn Raw' if nothing else works.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
