| Post 1 made on Tuesday November 1, 2005 at 09:08 |
3dawgs Lurking Member |
Joined:
Posts: | November 2005
4 |
|
|
I'm trying to get a friend's 880 configured for him, and something odd keeps happening. While testing everything after getting the 880 loaded up w/ programming, it'll just randomly black out on me. I'll shake it a bit, thinking that maybe it just went to sleep on me, but nothing. Finally after about 30-45 seconds, it wakes back up.
I've never messed with this thing before...are the friggin batteries just going dead???
|
|
| Post 2 made on Thursday November 3, 2005 at 18:36 |
Take the battery out, give it a light shake, wait a few minutes then put battery back in.
|
|
| Post 3 made on Thursday November 3, 2005 at 18:39 |
Give the H880 a shake that is!
|
|
| Post 4 made on Friday November 4, 2005 at 08:55 |
kschonha Long Time Member |
Joined:
Posts: | August 2005
13 |
|
|
I had a similar problem. The likely cause is poor contact (insufficient tension) against the battery terminals. A temporary solution is to take out the battery and place a small piece of foam rubber at the bottom of the battery (opposite end from the terminals). Attach it with a small piece of scotch tape. That should increase the tension and improve contact. The more permanent solution is a replacement 880.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
