| Post 1 made on Sunday October 30, 2005 at 14:27 |
slalomguy Lurking Member |
Joined:
Posts: | October 2005
9 |
|
|
Just a small problem with my 880 .
When I increase the volume on my Panasonic monitors built in speakers it is pretty fast and seamless but when I decrease the volume the response is slow.
A seperate button press is required to decrease the volume by a single notch.
I have the Inter-key delay set at zero.
I dont know if this is a inherent issue with Panasonic but when I use the supplied remote it is seamless when I increase or decrease the volume.
Anyone have any ideas?
|
|
| Post 2 made on Sunday October 30, 2005 at 16:08 |
remotevisitor Long Time Member |
Joined:
Posts: | February 2005
205 |
|
|
Your description would suggest that the command generated by the 880 for the decrease volume is only sometimes being correctly recognised by the Panasonic.
Did you learn the commands for your Panasonic from the original remote or did you use the harmony online database? If the later case I would first suggest that you try learning the decrease volume command directly from your original remote.
If that doesn't work try relearning the command in Raw mode.
|
|
| Post 3 made on Sunday October 30, 2005 at 19:10 |
shorthand Advanced Member |
Joined:
Posts: | September 2004
771 |
|
|
Actually, before relearning the command in RAW mode, I'd probably recommend you go under troubleshooting for that device and follow the steps under "Not all commands recieved correctly." - you'll end up adjusting the number of repeats.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
