| Post 1 made on Monday October 20, 2014 at 20:37 |
Germanicus Long Time Member |
|
|
Hello, I'm trying to do what should be a simple procedure, that is changing a zone name. When the name is changed, and the transfer button is pushed, I get an error message "at least one device is not connected to a zone", and the transfer will not occur. Any ideas what the problem may be? thanks
|
|
| Post 2 made on Tuesday October 21, 2014 at 08:22 |
BandW Long Time Member |
Joined:
Posts: | September 2012
87 |
|
|
I've only received that message when I have a single/contact/display not connected to a zone.
|
|
| Post 3 made on Tuesday October 21, 2014 at 10:39 |
rbhfan Active Member |
Joined:
Posts: | March 2003
634 |
|
|
yes if there are any pads discovered in programming that aren't assigned to zones you will get this message
|
One thing I have learned in this industry. It is easier to pull a wire than it is to push one. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
