The latest update to g! has finally added support for Wirepath DVRs, NVRs, and IP cameras. I just added our showroom WPS-100-DVR-8CH (even though it is not listed as a supported model) to our HC6 system. Adding the camera streams to the system was as easy as entering the IP address of the DVR. It really couldn't have been any easier.

Displaying the cameras seems to work pretty well. Sometimes the streams can take 5 seconds to 10 seconds to load though, which seems a bit slow.

The big disappointment however is motion detection is not support from any Wirepath devices, so using the g! DVR will not work. The driver does have support for the OSD commands. However, The driver does not allow you to view the OSD on the g! interface. My plan is to run the OSD output from the DVR back into one of the unused camera inputs and use that to stream the OSD back to the g! system. I'll then create a custom page with the OSD stream and commands for viewing the Wirepath recordings.