| Post 1 made on Monday August 6, 2012 at 16:19 |
bennettavi Active Member |
Joined:
Posts: | August 2003
675 |
|
|
What are you guys using to "plate up" VGA and HDMI inside of conduit compatible device boxes? We are running some cabling down a brick wall and want to give the clients a patch plate including VGA, HDMI, ethernet, and 3.5mm audio. I have used Wiremould products and Leviton in the past, but they are not deep enough to accommodate these specialty cables. I really dont want to chisel out the brick behind the box to allow for a proper bend radius. Thx in advance.
|
|
| Post 2 made on Monday August 6, 2012 at 16:27 |
ericspencer Active Member |
Joined:
Posts: | December 2011
532 |
|
|
|
| Post 3 made on Monday August 6, 2012 at 18:30 |
jmacdonald Active Member |
Joined:
Posts: | November 2006
695 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
