| Post 1 made on Saturday August 27, 2011 at 14:33 |
MrCcure Lurking Member |
Joined:
Posts: | December 2008
3 |
|
|
on site now, and need to do a "Factory Hard Reset" The software wont talk to the remote. Uploaded with MX-700 accidentally and adjusted and downloaded w/700 software now the remote when batteries are pulled go through the normal startup with "good" at each section. but screen comes up blank, there is a factory reset process that tech support gave me years ago about doing a forced reset and getting back to out of box default programming. Cannot communitcate into the remote any more.
Please help need assistance Now thank you
|
|
| Post 2 made on Saturday August 27, 2011 at 14:39 |
edmund Elite Member |
Joined:
Posts: | April 2002
13,822 |
|
|
press and hold STOP & MAIN together, then confirm you want to reset it.
|
|
| OP | Post 3 made on Saturday August 27, 2011 at 15:39 |
MrCcure Lurking Member |
Joined:
Posts: | December 2008
3 |
|
|
finally able to get things to reset using the Enter lower right, stop and main after battery pull and replace.
able to program again so I am all set now,
Thank you to all who had looked and responded, Thank you Edmond for your assistance
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
