| Post 1 made on Thursday July 14, 2011 at 12:45 |
jimstolz76 Loyal Member |
Joined:
Posts: | December 2007
5,607 |
|
|
Can I send commands to a Chief PXRU (which has an RS485 port) from a 'normal' RS232 port from a Control4 controller? The command structure looks simple, and it's not even 25 feet of Cat5. Not sure what else might be different. Only need one-way control, and if I can wire straight to this terminal strip then it will be the cleanest way to go.
edit - nevermind. just noticed you ONLY get preset controls via serial (plus feedback, which I don't need). You still have to use IR to do incremental controls...
|
|
|
| Post 2 made on Thursday July 14, 2011 at 13:14 |
edizzle Loyal Member |
Joined:
Posts: | March 2005
5,916 |
|
|
nice design on chiefs part! wtf do these guys thjink when they are building this stuff?
|
I love supporting product that supports me! |
|
| OP | Post 3 made on Thursday July 14, 2011 at 13:31 |
jimstolz76 Loyal Member |
Joined:
Posts: | December 2007
5,607 |
|
|
I know... I can ask the device for its serial number, but I can't say "go left".
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
