| Post 1 made on Thursday October 29, 2009 at 05:46 |
I'm sure this has been asked before but finding a thread with the letters "RF" in this forum is no easy task.
So my question is: Can a 9400 or 9600 learn/emulate an RF light / gate controller?
It is mainly for lighting so it would be very useful to have.
Kind regards
K
|
|
| Post 2 made on Thursday October 29, 2009 at 06:07 |
Lyndel McGee RC Moderator |
Joined:
Posts: | August 2001
12,910 |
|
|
I suspect you searched only for RF, and that's your problem.
How about RF Lighting Control? - Yields 26 threads including this one and for sure, different types of RF equipment are discussed. ;-)
Quick Answer - You are out of luck. The RF on 9400/9600 is Wi-Fi 802.11G only.
|
Lyndel McGee
Philips Pronto Addict/Beta Tester
|
|
| OP | Post 3 made on Thursday October 29, 2009 at 06:39 |
Thanks again Lyndel,
I suppose I would have to change/add the light controller for a Wifi/IR one.
I will look into it some more on these forums.
Thank you
|
|
| Post 4 made on Thursday October 29, 2009 at 15:43 |
Lyndel McGee RC Moderator |
Joined:
Posts: | August 2001
12,910 |
|
|
If the light controller gets put onto a wi-fi network, it would then likely be controlled via TCP/IP. Then, you'd need to use ProntoScript to communicate with the controller.
|
Lyndel McGee
Philips Pronto Addict/Beta Tester
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
