I have a theater section and a dining room section on the work remote. For the cable TV device I have a boatload of pages for each room. When I select the cable STB for the theater, Page 1 shows up on the remote, which is what I want. But, when I select the cable STB for the dining room, Page 2 shows up, which is not what I want. How do I get Page 1 to be the default initial page when the device is selected?

I've search the manual, but I found no mention as to how to do it. Any idea on how to set the default page?

Thanks in advance.

Highlight the button for the cable STB for the dining room, look at the Macro tab and you should see a Jump command with the destination in parentheses. Edit or delete and do a new Jump with desired destination.

On my 980 remote I have 8 pages under the right main key (FAVS, activities). I have Jump command on numerical keys 1 thru 8. That allows me to go direct to the desired page without paging left or right.

Thanks. Will take a look.

Can't do the numeric key jump shortcut. When the cable stb is selected, the numeric keys correspond to the stb's numeric keypad.

In case you look here again.

For the numerical keys use macros:

Do an IF command, click IF, select Press Time, use 1 second. Under IF use the desired numerical IR code.

Then under the ELSE insert the JUMP command to the desired destination.

Short press will operate the desired numerical key. Long press will Jump to the desired device/location.

I've long since fixed it. It was a program error as to where I jumped to.

Thanks for responding though.