Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Programming a Denon 4520CI
This thread has 1 response. Displaying all posts.
Post 1 made on Saturday February 23, 2013 at 14:19
TWells
Long Time Member
Joined:
Posts:
May 2002
48
Hi,

I am replacing my Onkyo TX-NR905 with a new Denon this week. I am currently using a MSC-400 with a MX-5000 for my control. I don't see the 4520 listed in the code set for 232 or IR. Any recommendations on which model Denon to select as my baseline? How about for 2-way? I assume I'll be able to set it up just like I did for my Onkyo.

I also might try IP control with this reprogram too. Any tips here? Looks similar to IR and 232 setup.

Finally, for anyone looking at this thread for help, since the code set is not in CCP, you'll have to manually configure some of the new codes to utilize new futures n this AVR. Here are links to the IR and RS-232 codes and protocol.

[Link: dl.dropbox.com]

[Link: audioproducts.com.au]

Thanks,
T.Wells
Post 2 made on Saturday February 23, 2013 at 15:59
Lowhz
Senior Member
Joined:
Posts:
April 2012
1,168
Denon codes never change. They just add some new ones.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse