I have had my MX-780 for almost a year. My watch blu-ray macro won't exceute the commands properly when I start with my home theater powered all off. It will turn on my Panasonic 60GT30, Anthem receiver and Oppo BD player. It will not change HDMI inputs on my tv or receiver. If I press the macro again, than it will change to proper inputs. I already have restarted my pc, erased the MX-780, removed batteries to no avail. I even erased the macro and restarted building, even putting extreme delays, it will not execute. Any ideas? I can't contact my dealer til tomorrow.
Plasma Power On 2.0 second delay Directv STB off Plasma HDMI 1 0.2 second delay Anthem power on 3.0 second delay Blu-ray power on 0.2 second delay Anthem BDP input
2 seconds is a very short delay for a tv. Not sure how long the Panny requires. I would try setting it to something like 10 seconds and if it works, decrease it by 1 second until it stops changing the input. Then put it back at the last time delay that worked.
I would do it like this unless you have a reason not to:
Plasma Power On Anthem power on Blu-ray power on Directv STB off 12.0 second delay - start here lower as needed - One of my plasma tv's take 12 seconds of delay. Plasma HDMI 1 Anthem BDP input
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.