Hi,
I am just setting up a system with the above components and and have had a hard time figuring out how to get the Mx-6000 to learn the code for the "power" command on the
Silverstone LC20B-M HTPC case. I have tried every angle I know including short delay in front of the learned code from the O.E remote also downloaded pronto edit program and extracted the hex code from the site here and dragged into hex editor in CCP.
I tried 2 learn, different repeat figures, double checked Ir emitters from mrf 350, tried IR only from the remote. I was able to teach a Nevo Q50 the code and had no problem with the power code. Also, even a old Marantz RC5000i.
I am new to CCP but have completed the job except for the HTPC power command. Just need the HTPC to power on and off then the customer will use a wireless keyboard.
Is there a way in CCP to extend the learn time of the software to allow what seems to be a code that is not be fully done before software says it has been successful?
Any help with this would be much appreciated.
Thanks
Rick
Continued: Well after hours of trying nothing has worked :(
I read all I could find and looks like I should be using this code.....just won't work....any idea's on this?
Thanks
Rick
Power=0000 0073 0000 001E 0070 0020 0010 0010 0010 0010 0010 0020 0010 0020 0020 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0AC6
Last edited by RickS on December 23, 2009 03:22.