Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


Set Variables in MX950 not running
This thread has no replies.
Post 1 made on Saturday December 19, 2009 at 19:15
Lurking Member
May 2007
In a macro, using the set command for a variable, when running the test, the macro stops before setting the variable. I just downloaded the latest version 1.10.151 Firmware 1:143 IR 1.92.

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse