Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from


MSC-400 Programming question
This thread has 1 response. Displaying all posts.
Post 1 made on Tuesday December 8, 2009 at 15:14
Long Time Member
October 2003
I have connected serial devices listed. I create a smart macro group for each device. I then drag the individual triggers from within the smart macro group(using Universal Browser) to my MX 3000 buttons. Works fine.

Lets say I extensively change the Func table for a particular device....or just add/change a few commands. What's the best way to handle this. If I create a new smart macro group for the device, I now have two smart macro groups for the same device. If I delete the old macro group, do I have to re-do all the triggers, not just the changed or added commands?

Or....would I have to select "add smart macro", in my existing smart macro group, for each new command in the func table and then drag the new func command over to it?  For the changed commands, (not new ones) I would delete the old command in the smart macro and drag the new command over.

Is there an easier way to approach this? Am I making any sense. :)


Post 2 made on Tuesday December 8, 2009 at 19:38
Long Time Member
May 2009
not really ;)

Jump to

Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse