| Post 1 made on Thursday January 8, 2009 at 16:59 |
michale6 Long Time Member |
Joined:
Posts: | November 2008
187 |
|
|
I recently programmed, and loaded a MX900. I unplugged the remote and tested. I plugged it back into my laptop to make some changes and it will no longer link. Has anyone else encountered this problem? If so is there a way to reset or reboot the remote to get it to link w/ my laptop? I'm tryiong to avoid replacing the remote. I've programmed several 900's since then using the same cable and they work, so my program and cable are good.
|
|
| Post 2 made on Friday January 9, 2009 at 16:39 |
goldenzrule Loyal Member |
Joined:
Posts: | July 2007
8,448 |
|
|
Have you tried using different usb ports? Sometimes during programming I have to change the wire to another port or it will not connect.
|
|
| OP | Post 3 made on Saturday January 10, 2009 at 11:58 |
michale6 Long Time Member |
Joined:
Posts: | November 2008
187 |
|
|
I did not try that, but I have programmed other remotes using the same usb port I always use and they worked fine. I have noticed the newer 900's have a much tighter plug(on the remote) so you have to pull hard to get it to unplug. I think that may have loosened the internal connections in the remote
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
