Yesterday, when i was trying to finish up at a clients house i noticed that the remote wasn't functioning like i thought that i had programmed it so i plugged it back into the laptop and went to upload to fix it and the MX3000 editor wouldn't open? It would get almost open and say it had encountered a problem and then shut down. Then after it had closed i would get a microsoft .net fault which would then close the conplete control software? I can open and work on all of the other remotes just not the MX3000? Today for the last 5 hours or so i've uninstalled everything including .net and reinstalled with no success. I've tried cleaning out the registry after uninstalling and just about everything i can think of. Any ideas? Anybody? I've got two to get done by tomorrow and another two to do on tuesday so needless to say this sucks right now!