Your Universal Remote Control Center
Philips iPronto Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Sunday May 25, 2003 at 09:29
Founding Member
May 2002
I'm using the latest firmware and software. I imported my CCF file from my 6000 into prontoedit and downloaded into the ipronto.

First thing I notice is that none of the IR functions transfer. I learn a few IR codes and upload the ICF back into the Iprontoedit, move some buttons aroound and send it back into the ipronto. Yet none of the commands I had learned are there????

Any Help. Pls. no ranting about it's a piece of junk. So I likethe unit. I can see four panels at a time on the ipronto - that's cool

Hosting Services by ipHouse