Your Universal Remote Control Center
RemoteCentral.com
General Consumer Remotes Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 2 made on Friday March 8, 2002 at 19:11
BruceMorris
Founding Member
Joined:
Posts:
March 2002
8
I have the same remote that came with my Integra DTR 6.2. Haven't tried learning mode, but it worked fine in the "code entry" mode (entering pre-set codes for controlling other devices). Note that the instructions are written poorly, and it would be easy to mis-interpret what they are saying. First, be sure you are holding down the right "mode" button. DO NOT press the MODE button that is just below the light button. You want to press and hold one of the "device mode" buttons such as DVD, MD, SAT, VCR, etc.

Now, all you do is hold down the device mode button for the device you want to learn a code, then press the ENTER button (bottom right) to enter learning mode. Then release both buttons at the same time.

I note that you mention learing the pre-set codes for Phillips and Magnavox. To enter these codes, you first hold down the proper device mode button, then press the DISPLAY button (bottom left). As above, release both buttons together and you are ready to enter your device code.

Hope this helps. If this doesn't work, your remote is probably defective.


Hosting Services by ipHouse