Your Universal Remote Control Center
RemoteCentral.com
Sony Remote Controls Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 40 made on Tuesday October 10, 2006 at 14:41
Ron Aronson
Super Member
Joined:
Posts:
June 2002
3,967
On September 25, 2006 at 14:15, kingwr12 said...
For the DG600 I would try the same technique as the DG800.
On the unit, turn on the unit while holding "Input Mode"
to toggle between AV1 and AV2. On the remote, press and
hold "Remote Setup" until the light on, press 1 for AV1
or 2 for AV2, then enter. Light flashes then goes out.

If I change my system to AV1, can anyone point me to a
component page for my pronto that will work on AV1?

Thanks for the info. I have updated this thread accordingly.

I don't know anything about a Pronto, but the standard Sony component code will work with AV1, so you can either use the Receiver page, or do whatever makes the Pronto assign a receiver to another component screen.


Hosting Services by ipHouse