Your Universal Remote Control Center
Philips Pronto NG Family Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 2 made on Thursday December 26, 2019 at 10:54
Long Time Member
September 2002

1. You cannot learn RF. The RF in the remote is used to talk to the RF to IR extender of the Pronto and even then, it is a certain frequency and speaks a certain protocol. I'm sure with some not-so-insignificant engineering you could get this to work, but I doubt it's worth your time.

2. Go to the files sections and search for Roku. There are older device pages that already have the codes embedded in them. You may not get all the buttons, but you will get the important ones. Not sure why you can't learn them though. Are you usre you're pointed at the correct end of the Pronto remote? Are you sure you're going through the correct set of steps to "learn"?
Never underestimate the predictability of stupidity

Hosting Services by ipHouse