On July 19, 2018 at 08:47, Duct Tape said...
i'm not sure on an mx350, but on URC remotes compatible with CCP, you can go in and crank up the repeat rate of the menu IR code. this simulates a press and hold of the menu button on the AppleTV remote, which takes you to the home menu.
if you can't adjust that repeat setting on the mx350, just try pressing and holding the menu button to go back home.
Pressing and holding the existing menu button on the MX-350 did not work.
However, I ran the Apple remote setup process on a 2nd universal remote and than set the MX-350 into learn mode assigning it a new button called HOME. On the 2nd universal remote I "pressed-and-held" the menu button while teaching it to the MX-350 (that is, instead of just pressing "menu" I pressed-and-held "menu" while learning).
This worked! The MX-350 now has a Home button.
Thanks so much for your post, Duct Tape.