Your Universal Remote Control Center
RS-232 & IP Control Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Tuesday December 15, 2015 at 10:27
Lurking Member
December 2015
Hey all,

Working with a Sony XBR-55X810C (one of the newer 4K sets) and I'm butting up against an issue where older legacy RS232 codes programmed into my AV control system aren't working with these new displays.

The same codes have worked without a problem on every sony display with an rs232 port since 2008, but I figured someone on here might have some insight?

Next bit - anyone familiar with an issue where these displays power on when connected HDMI devices start sending video? I have media players that automatically output video received over multicast, and when they first boot up it looks like that initial signal causes the display to power on. Just trying to find a workaround.

- IV

Hosting Services by ipHouse