Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 3 made on Tuesday March 26, 2013 at 14:11
Duct Tape
Loyal Member
November 2008
incorrect as far as the MRX1 goes.  no codes are stored in the MRX1, they are stored on the buttons inside the network based remote (mx5000, mx6000, kp4000, or mxiOS)

the issue he is having is that before CCP allows you to put an RS232 code on a button, it wants to know which MRX1 port you will be routing the data to.  This info doesn't get brought over when importing the RS232 device, so you end up losing all RS232 data programmed to each button.

Hosting Services by ipHouse