Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Friday March 8, 2013 at 09:13
Long Time Member
January 2013

I recently purchased a used MSC-400 with CCP. I have an MX-3000 remote.

Everything was going along smoothly until I tried to use universal browser to copy the triggers into the remote. MX-3000 editor Universal Browser does not recognize .ccp files! So what do I do? Do I have a chance by going to a dealer in getting the MSC-400 stand alone editor? In other words, would it be in the dealer's right to issue a stand alone editor in this case even though I didn't buy anything from him?

Secondly, I ASSUME (because ccp let me do it) that Tools/Convert to SmartMacro Group works for IR also. The documentation only talks about RS232 conversion to SmartMacro. Is it correct to assume that the hugely time saving tool to convert Connected Devices to Smart Macro will work for IR also?


Hosting Services by ipHouse