Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Thursday March 7, 2013 at 23:48
Lurking Member
March 2013
Just got my MX-780 and MRF-260 setup and programmed and everything is working great except for macros. I have macros setup to turn everything on and set inputs. in the transporter page i drag the power on command to my macro. Everything looks fine, but the command only works line of sight/ IR in the macro. if i click the receiver on the remote then all the commands go through RF. I cant seem to figure out how to get it to send the Commands through RF in the Macros. It only sends commands in macros through IR.

Hosting Services by ipHouse