On December 15, 2012 at 17:41, dalto said...
To set the RF id, go into "configure home" click on the mrf-260 in the left pain and click properties at the bottom.
Thanks, turns out it was already set to 1.
You can turn IR and RF off an on per device. So if you want IR on your TV and RF for your integra you can these individually under "Program" and then "RF Control" using the "Signal" dropdown.
Yes, but doesn't "IR&RF" permit either signal which is what I'd prefer?
I would definitely test using an emitter first if you are having problems because the emitter will light up when you send a signal to let you know you are routing to the right ports.
Didn't realize the emitters should light up, will check that.
I would think using fixed ports would be fine for this but I haven't used an MRF-260 in a long time. I vastly prefer the 350's
Was looking these up but it seemed from what I could find online that these were somewhat overkill for my application.
Thanks again for the help!