Set to channel 1. Though I don't see any option in the CCP software to select the Receiver ID # as per page 9 of the MRF manual?
Configured the remote to send IR&RF for the device vs just RF. Can try just RF if that is the issue but I also have some of the same components upstairs (just the bluray player and Cisco box) that I won't be using RF on, hence the IR&RF selection.
I have setup the 4 Ports on the MRF to the devices properly (e.g., Port 1 is set to the Integra for instance), if that is what you mean by routing.
Didn't try the last one yet.
Thanks for the quick response!
Looking at the MRF-260 manual, I think I had the Cisco Cable box IR in connected to the fixed IR output on the MRF instead of the variable (though the Integra was connected via the variable one). I assume both should be connected to the variable ones for the IR ins to work on the components?
Surprised that I couldn't operate the components at all with the 3.5mm cables connected to their IR ins, even with their OEM remotes?