On December 2, 2012 at 09:01, Duct Tape said...
If/when you ever need to use an rf basestation and need to route ir devices to specific ports, you will wish you hadn't done it like that.
Exactly.
I too used to build my macros with the MX900 Editor and then move the buttons. It worked fine. With CCP, that is not the case. However, it really is not a big issue. How often are you aliasing commands from lets say, a cable box? Not sure about others, but I place my TV, receiver, and other devices that a client does not need access to on a hidden page. The layout of the buttons in these devices are a non-issue, as the client never sees them. What the client sees is the Cable Box pages, BDP pages... These pages will typically contain no buttons or codes that are aliased anywhere.