I am on site at a customer with equipment that was existing when he purchased his house. I am adding a MRF350 among other things. The issues I am having is with the power codes not aliasing properly. Everything is programmed as it should, macros looks proper, but when I run a macro, certain codes do not fire. I have the emitters assigned, not on address 0, and no interference present. When I test the codes from within the device (i.e. go into the Receiver device and test the power on or off commands directly), the codes work fine. When I enter those same codes into the macros, they do not even fire, as evidenced by the emitters not flashing. I rearranged the codes within the macro, and the receiver codes were firing, but now the TV codes were not. Added .1 second delays between commands, removed delays, added multiple power commands, all with no effect. I also checked and the remotes battery is fully charged. Not sure what is going on, anyone have any thoughts?