Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto Professional Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Saturday September 18, 2010 at 13:34
rap
Long Time Member
Joined:
Posts:
September 2006
59
Coming up to speed on PEP2, latest version and latest version of firmware.

Working through a project I noticed that jump & execute doesn't work in the simulator but works just fine on the TSU9400 panel.

I have a button with one action-> Jump & Execute

The landing page immediately jump to Please Wait #1, cycles through a few actions and jumps back to where I want it.

All works on the TSU fine, it will not simulate though.

However, a simple Jump command will.

Any clues?

Thank you,

OK...Just noticed the "CommandFailed on the simulator panel. Buy why? I deselected the "Extender" and voila, the simulator began working. Does this make any sense? It seems nuts-o to turn the extender off on all the device to test/simulate and need to enable it before loading the panel. This can't be, can it?

Last edited by rap on September 18, 2010 15:03.


Hosting Services by ipHouse