Post 10 made on Friday September 3, 2010 at 20:14 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,298 |
|
|
is the matrix mounted close to the msc400? the serial protocol looks pretty simple. You would most likely need a female serial cable. Set up the port for 9600,n,8,1 Commands need to be set for Hex If I am understanding the protocol sheet correctly. [Link: monoprice.com]Power 10,EF,D5,7B A1 00,FF,D5,7B A2 01,FE,D5,7B A3 02,FD,D5,7B A4 03,FC,D5,7B B1 04,FB,D5,7B B2 05,FA,D5,7B B3 06,F9,D5,7B B4 07,F8,D5,7B Are you using CCP? or the stand alone editors?
|
|
|
|