I lost the remote for my Chiro C800 - anyone selling it? Or can anyone advise which universal remote to buy to program/load the hex codes published on this website?

Thanks,

Rodel

This uses the RC5 IR protocol, using device 28. Nearly any remote made by Universal Electronics can be programmed (by assigning 5 digit EFCs to each button) to control the C800.

I'm not sure which remotes are available to you. In the USA, Comcast or the Atlas remotes used by some cable companies have a setup code which can be adapted. Many OneForAll, Radio Shack 15-100/133/134/135, high end Vizio TV remotes, etc. can be modified.

If you simply wish to buy one, the RCA RCRP05B (Walgreens, Best Buy) or OneForAll URC-8820 (Sears) are less than $20.

Setup code Audio 1189 can be found in most of these remotes; several other setup codes are also useable.

To assign Volume Up:
First press the device mode button that you assigned Audio 1189 to (Probably Audio)
1) Press Setup (or Set or Magic) until 2 blinks
2) Enter 994
3) Press Setup briefly
4) Enter 21057
5) Press the Vol+ button
The remote should blink twice.

Here are some EFCs. If you decide to go this route, post back and I'll fill out the list of EFCs.

Vol + 21057
Vol - 21181
Mute 21177
Power On 20993
Power Off 21113

Yes, please greatly appreciate for the EFC list. Thanks so much.

10	21009
1	21053
2	21041
3	21045
4	21033
5	21037
6	21025
7	21029
8	21017
9	21021
vol up	21057
vol down	21181
mute	21177
Power On	20993
Power Off	21113
AM/FM	21001
Cal/Set	21005
THX	21089
Dolby	21109
Stereo	21081
Enhance	21117
Tuner	21061
CD	21069
Acr	21077
Aux1	21105
Aux2	21085
TV	21101
LD	21093
VCR1	21065
VCR2	21073
Display	21097
Seek +	21013
Seek -	20997

thank you

Hi,

Do you and anyone know of other remotes that will work with a Chiro C-800? Hard to find these and non of the electronic stores know the technology.

Thanks.