Anyone have success with this model controlling 232? All commands work fine when the projector is in the "ON" state, as soon as I issue the "Off" command the projector turns off and will not recognize the "ON" command. Projector returns "F" (fail).. Any tips?

buuummmp

Is there really no one out there?

I think I might be sticking an emitter even though its against my better judgement......
please help

I am sitting here with mine, having the exact same problem. Tech Support says there are no problems reported..

OK, I got mine to work. Tech support was totally useless, kept talking about the baud rate, meanwhile I was getting commands going back and forth.

I am controlling with a crestron processor, and the solution was to put the serial pacing to 1ms. The part of the projector you are talking to when it is OFF, is different than when it is ON and requires a slower rate.

Good luck.

Will

have you used also pins 7 and 8 and twist them as they use null modem?

I have an HD78DC3 and have been sucessul with rs232 control.I am not sure if they use the same commands but mayeb this will help.

Off
* 0 IR 002\r