| Post 1 made on Friday July 24, 2009 at 20:08 |
I want to control Polycom VSX-8000 via RS232. I programmed few buttons to replicate the number pad but there was no response. Below is the code that I used for Number 1.
button 1 + CR + LF
I have made sure that the COM properties match on my computer and the Polycom unit.
I would appreciate if anyone can help me out in figuring what is wrong in the code.
|
Keyur Sheth [email protected]Application Engineer |
|
| Post 2 made on Tuesday July 28, 2009 at 16:56 |
Bruce Sinclair Active Member |
Joined:
Posts: | April 2003
694 |
|
|
what control system are you using?
|
Bruce Sinclair CMB Integrations LLC DMC-E
"Those who are most critical, often have no real skills themsevles" |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
