On January 17, 2015 at 07:13, skeets1skeets said...
I need to control an Enntec dmx streamer with a Rako control plate using rs232 commands. The problem im having is the Enntec code, I have the serial communication protocol pdf file but cant figure it out. Any help would be appreciated.
HA to HZ Command, Set Show to Run
This command will set the show to run, HA is the first show HB the second and so on.
To Run a diferent show you must first stop the current show, set the show to run and then start the
show again.
Eg:
To run show C you would send the following commands:
H1 HC H0