Post 1 made on Monday January 12, 2015 at 11:30 |
benjh1028 Long Time Member |
|
|
Using a URC KP-4000 mated to a MRX-1. Have most serial commands working, but no luck with the "Power On" command. Here is what I'm sending:
\x02\x03\xD0`\x01\xCC
I'm getting ACK returned when sending the POWER ON command only when the unit is already on.
Appreciate anybody here that may have the answer!
|
|
Post 2 made on Monday January 12, 2015 at 15:41 |
mark65 Long Time Member |
Joined: Posts: | November 2003 450 |
|
|
I believe it should be: 02 03 D0 60 01 CC
There is a note in the protocol sheet that says the Power On command should be sent continuously every 100ms until the unit responds.
|
|
OP | Post 3 made on Monday January 12, 2015 at 20:22 |
benjh1028 Long Time Member |
|
|
Thanks Mark! The continuous send did the trick!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.