Post 1 made on Thursday July 4, 2013 at 09:57 |
Warren Long Time Member |
Joined: Posts: | November 2002 264 |
|
|
#DEVICE,2,4,3
Realize this is a super basic question, but still need the answer.
When tying in the above example Radio Ra2 command into RTI software, Do I literally type in the carriage return or enter it as shown ?
Same question for the Line Feed command.
Have not "messed" with RS 232 and am only needing a few very basic commands to work via the RTI remote. Basically, I only need key pad button presses. I don't need any extensive control of RadioRa2 from the remote control.
Thanks.
EDIT: Interesting, but when posted the info in the brackets gets removed from my post. Should show (CR) (LF) at the end, but with <> symbols instead of ()
|
|
Post 2 made on Thursday July 4, 2013 at 21:16 |
Total Control Remotes Super Member |
Joined: Posts: | July 2006 2,987 |
|
|
Your command needs a \r at the end.
|
|
OP | Post 3 made on Friday July 5, 2013 at 05:51 |
Warren Long Time Member |
Joined: Posts: | November 2002 264 |
|
|
Thanks. Caught that the software was entering the commands in that manner.
In a place with no phone or internet service of any kind, so no on site help from Tech support. Praying the RTI commands work right out of the box.
If not, what's another trip to the beautiful countryside. :)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.