Post 1 made on Tuesday June 18, 2013 at 11:00 |
KNX-Integrator Lurking Member |
|
|
Hi
I found this forum when I was searching for an answer to my problem with c4630.
I want to control it with rs232 commands and I have recorded the communication in a hyperterminal and think I have the right commands.
Example: Zone 1 On, ":Z11<-->" (--=cr) Zone 1 Off, ":Z10<-->"
Baud rate 19200, 8N1
But I can´t make it work! Anyone who have an idea?
If you wonder I use a KNX system for communication.
/Andreas
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.