Your Universal Remote Control Center
RemoteCentral.com
RS-232 & IP Control Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
HAI HTX2 & Xantech HD88CC5 Control Issues
This thread has 1 response. Displaying all posts.
Post 1 made on Saturday April 27, 2013 at 17:48
EmergentAV
Lurking Member
Joined:
Posts:
April 2013
1
I am trying to serial control the Xantech via this HAI device. All wiring tests well. Getting 5.7VDC on TX and 0 across RX connected. Baud rate at 9600. !1SS2+ is my test code in system but no change in software test or uploaded GUI. I've tried /CR...forums and tech docs show no need for null. Firmware across all subsystems are latest...I am at a loss. IR for same device are controlling perfect over iPhone within same program.

Am I missing something?
Post 2 made on Thursday August 1, 2013 at 09:00
jeroenV
Long Time Member
Joined:
Posts:
April 2012
15
No !1PR1+ is the code I use with URC to power on my MRC-88. It needs a CR after every command. Try \x0D instead of /CR.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse