Post 1 made on Thursday April 28, 2011 at 11:35 |
I have a tandberg codec that I am controlling via a crestron. so I know the rs232 works. however when I try to go directly into the tandberg via hyper terminal, it will not communicate via rs232. It will work via tcp. the cable is good since I can connect to other devices. any suggestions?
|
|
Post 2 made on Wednesday May 11, 2011 at 23:37 |
LiveWire Active Member |
Joined: Posts: | December 2004 524 |
|
|
|
Post 3 made on Friday May 13, 2011 at 13:00 |
Bruce Sinclair Active Member |
Joined: Posts: | April 2003 694 |
|
|
sometimes with hyperterminal you can't enter the command fast enough and it times out and the device ignores the command. I found this out with a Christie projector and power on (PWR1) it would ignore it every time but when using a utility that enters the command all at once it worked.
|
Bruce Sinclair CMB Integrations LLC DMC-E "Those who are most critical, often have no real skills themsevles" |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.