|
|
|
RS-232 & IP Control Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
TOA mixer control via RS-232
| |
|
Topic: | TOA mixer control via RS-232 This thread has 4 replies. Displaying all posts. |
|
Post 1 made on Monday May 4, 2009 at 01:14 |
bluerhythmav Long Time Member |
Joined: Posts: | January 2008 379 |
|
|
ALSO posted in RTI forum...
Hi all, up late programming and about to pull my hair out. Does anyone have experience controlling a TOA D-901 mixer via RS-232? I'm following the protocol and not having any luck.
RTI RK2 with RP6 and CM-232.
I've checked pin-outs and that's fine, and I've tried a few variations on the commands, to no avail. Example:
For output channel one, volume step up by 3, here's what the spec says:
91H, 03H, 01H, 00H, 43H
Where 91H is the command, 03H is data length, 01H is channel attribute (output channel), 00H is the Channel Number (one), and 43H is a 3 step up in gain. By the book.
And that's all it gives ya! Anyone have any tricks they can offer?
|
Blue Rhythm Audio/Video |
|
Post 2 made on Monday May 4, 2009 at 09:51 |
Bruce Sinclair Active Member |
Joined: Posts: | April 2003 694 |
|
|
Could be a few things. Depending on how the RTI system likes to see strings expressed. The Crestron module spits out the following string to raise the volume of output one a single increment step:
\x91\x03\x01\x01\x41
Baud rate 115200 8, 1, none
|
Bruce Sinclair CMB Integrations LLC DMC-E "Those who are most critical, often have no real skills themsevles" |
|
OP | Post 3 made on Tuesday May 5, 2009 at 00:00 |
bluerhythmav Long Time Member |
Joined: Posts: | January 2008 379 |
|
|
Got it running now, thanks for the help! Manual was a bit sketchy on command strings, if you enter it as thus in HEX mode:
91 03 01 00 14
It works fine. It essentially turns into what you have above when you switch over to ASCII.
|
Blue Rhythm Audio/Video |
|
Post 4 made on Wednesday March 28, 2012 at 13:49 |
sceneselect Long Time Member |
Joined: Posts: | March 2012 425 |
|
|
Hiya- I am in this situation currently with a 9000 M2 and have limited control with RTI. I have about 6 working commands and am unable to shut off phantom power or turn channels on or off. Do you have any further examples you could share (that work).
Thank you, Alex
|
|
|
Post 5 made on Monday January 19, 2015 at 09:16 |
AVCC Lurking Member |
Joined: Posts: | January 2015 1 |
|
|
hello just configuring a TOA D901 and having the same issues By any chance do you have the rti CML Rs232 for the d901 thanks
|
RTI |
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|