Post 1 made on Thursday February 3, 2011 at 00:15 |
puru23 Lurking Member |
Joined: Posts: | February 2011 2 |
|
|
I am using XTR39 universal Remote & Cbus protocol. When I use an RS232 command in hyperterminal which is connected to PC interface of clipsal by RS232 chord, I am getting an output. But when I am using the same command in XTR39, not getting any output. Please let me know how to use RS232 command in XTR39.
|
purushottam |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.