| Post 1 made on Monday January 17, 2011 at 17:42 |
alexsquared Lurking Member |
Joined:
Posts: | January 2011
3 |
|
|
Hey everyone. AMX programmer here. We just purchased two IN2116 projectors from Infocus, and I'm in the process of working on the programming for them. I have been able to get nothing to work. I have a 3 wire (cross over) cable made up and just inspected all terminations again to verify. baud rates are setup properly (I changed it on the PJ to 19,200). I'm getting 0 control. One thing I also noticed is that Infocus seems to have changed their RS232 protocol, but I've already accounted for that. I'm kind of at a loss here and hoping to get some help.
I have also turned on notifications to monitor for activity and turned the projectors on and off (via the remote), but nothing is coming through.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
