| Post 1 made on Wednesday November 10, 2010 at 17:16 |
Neil Williams Lurking Member |
Joined:
Posts: | November 2010
2 |
|
|
Hi all,
Been doing RS232 command for a few years and would like to move with the times and start using IP commands.
Any advise on where to start I have no background of the code's used or any thing...
We use RTi, URC, Pronto (RIP) and would like to build knowledge up too install a varity or IP labelled products.
Where does the IP database come from (Manufactures?) or do we have to intergrate the network for the commands?
Thanks.
|
|
| Post 2 made on Wednesday November 10, 2010 at 19:12 |
vbova27 Super Member |
Joined:
Posts: | July 2006
2,987 |
|
|
There may be a lot of IP devices onthe market, but not alot of them allow you to control them via IP. That is because the API for various products is not readily available and/or not released by the company.
Your first step is to pick a manufacturer that is controllable via IP and get the API and figure out how to reverse it inside your application.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
