| Post 1 made on Thursday September 30, 2010 at 12:16 |
sombrero81 Lurking Member |
Joined:
Posts: | September 2010
1 |
|
|
I have this plasma in a conference room and i need to hook up Component cables to the back of the TV and run them to the table. I want to give the option for connecting either Component or RGB. i can do this but i need to go into the menue and tell it what cable is connected.
I have a crestron touchpanel connected and i want to be able to send the codes from that to the TV to switch either RGB or component.
looking on the manual it doesnt say anything about Slot3
anyone know if there is a master list for RS-232 codes or if this can be done.
|
|
| Post 2 made on Friday October 1, 2010 at 12:49 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,793 |
|
|
232 for slot 3 is
SL3 Just the same as 2 but make the 2 a 3. there is not an A/B for the card
\x02IMS:SL3\x03
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
| Post 3 made on Saturday October 2, 2010 at 07:14 |
fpmunier Lurking Member |
Joined:
Posts: | September 2010
9 |
|
|
All the RS232 codes are in the user manual which can be downloaded from Panasonic site.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
