Post 1 made on Wednesday April 21, 2010 at 08:33 |
Matt Founding Member |
Joined: Posts: | August 2001 1,802 |
|
|
I have the protocol, and the listed commands work just fine but unfortunately they do not have direct Menu On/Off or cursor commands etc. But there is a command listed that is supposed to emulate IR commands, again unfortunately, the command list is not given in the manual.
The command is as follows
[!] [82h] [80h] [R] [C] x x x x [0Ah]
where x x x x is supposed to be the 4 bytes of the remote code. and x = 1-9, or A-F ASCII
I did find some listing in other manuals, for instance telling me the device code was [73h] and the remote code was [2Eh] but i entered 732E for the x's in the above example (and reversed them for a test) and still no go.
Any ideas?
|
|
OP | Post 2 made on Wednesday April 21, 2010 at 10:21 |
Matt Founding Member |
Joined: Posts: | August 2001 1,802 |
|
|
Or, maybe there is someone here that can take the codes from the URC MX editors and see if I have the device code / remote codes correct?
I could send you the device file if you need.
|
|
OP | Post 3 made on Wednesday April 21, 2010 at 21:52 |
Matt Founding Member |
Joined: Posts: | August 2001 1,802 |
|
|
Solved...via the awesome users in the Pronto forum!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.