| Post 16 made on Friday October 2, 2009 at 02:31 |
Benford AV Active Member |
Joined:
Posts: | August 2007
590 |
|
|
The light will only flash when data is transmitted through the GUC232.
Did you say that you are using a CM232 on MPIO Port #8? If so your programming on [C] Port 8 (Not [R] Port 8) should be correct.
|
Benford Audio/video www.benfordav.comMy favorites: RTI, Niles, Lutron |
|
| Post 17 made on Friday October 2, 2009 at 05:51 |
ahentertainment Junior Member |
Joined:
Posts: | March 2008
38 |
|
|
|
Turned out to be two things. The first was I had a bad cable for the multipurpose port. The second was a power cycle. A red button reset wouldn't do it but pulling the power cord did. Thanks for all of the help. Using the serial commands with these boxes is awesome. I can't believe how nice it is with the direct channel access. I wish I could do that with every cable box.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
